Ford Ecosport: Intake Air Distribution and Filtering - 2.0L Duratec-HE (129kW/175PS) / Removal and Installation - Air Cleaner Outlet Pipe
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
-
Disconnect and position aside the vent tube.
-
Loosen the clamps, disconnect and remove the air cleaner outlet pipe.
Torque:
35 lb.in (4 Nm)
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Loosen the clamp and disconnect the MAF sensor electrical connector...
Other information:
B0011:11, B0011:12, B0011:13, B0011:1A
Refer to Wiring Diagrams Cell 46 for schematic and connector information.
Normal Operation and Fault Conditions
The RCM continuously monitors the passenger airbag stage 2 circuits for the following faults:
Resistance out of range
Unexpected voltage
Short to ground
Faulted passenger airbag
If a fault i..
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH side similar.
Open the rear door.
Remove the check arm bolt.
Torque:
17 lb.ft (23 Nm)
Remove the rear door trim panel.
Refer to: Rear Door Trim Panel (501-..