Ford Ecosport: Body Closures / Removal and Installation - Rear Door Hinge

Ford Ecosport 2014-2026 Service and Repair Manual / Body and Paint / Body Closures / Removal and Installation - Rear Door Hinge

Removal

NOTE: Removal steps in this procedure may contain installation details.

Remove the rear door.
Refer to: Rear Door (501-03 Body Closures, Removal and Installation).

- Remove the rear door hinge screw.
  Torque: 89 lb.in (10 Nm)
- Remove the rear door upper hinge nuts.
  Torque: 17 lb.ft (23 Nm)
- Remove the bolts and rear door hinge.
  Torque: 26 lb.ft (35 Nm)

Installation

To install, reverse the removal procedure.

Check the alignment and correct if necessary.
Refer to: Rear Door Alignment (501-03 Body Closures, General Procedures).

Removal and Installation - Rear Door Check Arm

Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: LH side shown, RH side similar. Open the rear door...

Removal and Installation - Spare Wheel Mounting Bracket

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the bolts and the spare wheel and tire...

Other information:

Ford Ecosport 2014-2026 Service and Repair Manual: Diagnosis and Testing - Pinpoint Test - DTC: AR, Vehicles With: Rear Seat Side Airbag

B1405:11, B1405:12, B1405:13, B1405:1A Refer to Wiring Diagrams Cell 46 for schematic and connector information. Normal Operation and Fault Conditions The RCM continuously monitors the driver side air curtain circuits for the following faults: Resistance out of range Unexpected voltage Short to ground Faulted driver side air curtain If a f..

Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - Rear Shock Absorber

Special Tool(s) / General Equipment Transmission Jack Removal NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems. Failure of these fasteners may result in major service expense. Use the same or equivalent parts if replacement is necessary. Do not use a replacement part of lesser quality or substitute desi..

Removal and Installation - Steering Column Shaft

Removal

NOTE: Removal steps in this procedure may contain installation details.

NOTICE: Do not allow the steering column to rotate while the steering column shaft is disconnected or damage to the steering column internal sensor may result.

NOTE: Use a steering wheel holding device (such as Hunter® 28-75-1 or equivalent)

Hold the steering wheel in the straight-ahead position.