Ford Ecosport: Body Closures / Removal and Installation - Rear Door
Special Tool(s) /
General Equipment
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH side similar.
-
Open the rear door.
-
Remove the check arm bolt.
Torque:
17 lb.ft (23 Nm)
-
Disconnect the rear door electrical connector.
-
Remove the door hinge pivot bolts.
Use the General Equipment: Door Lift
Torque:
22 lb.ft (30 Nm)
-
Remove the rear door.
Use the General Equipment: Door Lift
Installation
-
To install, reverse the removal procedure.
-
NOTE:
This step is only necessary when installing a new component.
Check the body-to-rear door dimensions. Align the door as necessary.
Refer to: Rear Door Alignment (501-03 Body Closures, General Procedures).
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the liftgate.
Refer to: Liftgate (501-03 Body Closures, Removal and Installation)...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH side similar.
Open the rear door...
Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH side similar.
NOTICE:
Only use moderate force.
Using a non-marring trim removal tool, disengage the retainer clips, release adhesive tape and remove moulding...
B1202:11, B1202:12 and B1202:13
Refer to Wiring Diagrams Cell 46 for schematic and connector information.
Normal Operation and Fault Conditions
The RCM briefly activates the PAD indicator to prove-out and verify
correct functional operation of the PAD indicator to the occupants...