Ford Ecosport: Body Closures / Removal and Installation - Fuel Filler Door

Ford Ecosport 2014-2026 Service and Repair Manual / Body and Paint / Body Closures / Removal and Installation - Fuel Filler Door

Special Tool(s) / General Equipment

Flat-Bladed Screwdriver

Removal

NOTE: Removal steps in this procedure may contain installation details.

Open the fuel filler door.

Using a screwdriver, pry the retaining tab back and slide the fuel filler door from the fuel filler door hinge.
Use the General Equipment: Flat-Bladed Screwdriver

Installation

To install, reverse the removal procedure.

Removal and Installation - Front Door Check Arm

Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: LH side shown, RH side similar. Open the front door...

Removal and Installation - Fuel Filler Door Assembly

Special Tool(s) / General Equipment Flat Headed Screw Driver Knife Removal NOTE: Removal steps in this procedure may contain installation details...

Other information:

Ford Ecosport 2014-2026 Service and Repair Manual: Diagnosis and Testing - Pinpoint Test - DTC: AV, Vehicles With: Rear Seat Side Airbag

U0100:87 Normal Operation and Fault Conditions The BECMB uses information contained in messages from the PCM sent on the HS-CAN1 . DTC Fault Trigger Conditions DTC Description Fault Trigger Conditions U0100:87 Lost Communication with ECM/PCM “A”: Missing Message ..

Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - Instrument Panel

Special Tool(s) / General Equipment Locking Pliers Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: During the removal or installation of components, cap, tape or otherwise appropriately protect all openings and tubes/fittings to prevent the ingress of dirt or other contamination. Remove caps, tape and other protective m..

Removal and Installation - Front Brake Flexible Hose

Removal

Remove the wheel and tire.
Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation).

Remove the brake flexible hose bracket bolt.
Disconnect the brake tube fitting and remove the brake hose clip.
Loosen the brake hose fitting and remove the brake flexible hose.