Ford Ecosport: Interior Trim and Ornamentation / Removal and Installation - A-Pillar Trim Panel
Removal
NOTE:
RH shown, LH similar.
-
Position the front door weatherstrip aside.
-
Disconnect the tether clip from the A-pillar trim panel.
-
Release the A-pillar trim panel clip from the tether clip.
-
Rotate the tether clip line to align end with opening.
-
Slide tether clip end out of the A-pillar trim panel.
-
Remove the A-pillar trim panel.
-
Release the clips.
-
Lifting upward then rearward, release the lower tabs.
-
If equipped.
Disconnect the speaker electrical connector.
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
RH shown, LH similar.
NOTE:
Removal steps in this procedure may contain installation details.
Upper and Lower B-Pillar Trim Panels
Position the front door weatherstrip aside...
Other information:
Special Tool(s) /
General Equipment
8 mm Drill Bit
MIG/MAG Welding Equipment
Spot Weld Drill Bit
Locking Pliers
Materials
Name
Specification
Seam SealerTA-2-B, 3M™ 08308, LORD Fusor® 803DTM
-
Removal
NOTE:
Factory welds may be substituted with resistance or metal
inert gas (MIG) plug welds...
Low/Reverse Clutch
For low/reverse clutch operation, REFER to: Transmission
Description - System Operation and Component Description (307-01B
Automatic Transmission - 6-Speed Automatic Transmission – 6F35,
Description and Operation).
REFER to: Transmission Description (307-01B Automatic Transmission -
6-Speed Automatic Transmission – 6F35, Description and Operation)...