Ford Ecosport: Starting System - 2.0L Duratec-HE (129kW/175PS) / Description and Operation - Starting System - Overview
Starting System
The starting system controls the cranking of the engine. The
PCM energizes the starter relay when it receives inputs from the
ignition switch, automatic transmission, and the BCM . When the starter
relay is energized it applies power to the starter motor which cranks
the engine.
General Specifications
Item
Specification
Normal engine cranking speed
200-220 RPM
Starting circuit maximum voltage drop (Engine at normal operating temperature)
0...
System Operation
System Diagram
Item
Description
1
PCM
2
Starter relay
3
Starter motor
4
BCM
5
Automatic transmission
6
Ignition switch
Network Message Chart
Module Network Input Messages Powertrain Control Module (PCM) ..
Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the liftgate trim panel.
Refer to: Liftgate Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
Disconnect the electrical connector and remove the grommet.
Remove the nuts.
Torque:
35 lb.in (4 Nm)
..
Materials
Name
Specification
Motorcraft® MERCON® LV Automatic Transmission FluidXT-10-QLVC
WSS-M2C938-AMERCON® LV,
Check
Connect the diagnostic scan tool to the vehicle. Monitor the TFT
PID .
With the engine running in PARK on a level surface make
sure the transmission is at normal operating temperature 85-93° C
(185-2..