Ford Ecosport Owners and Service Manuals

Ford Ecosport: Parking Aid - Vehicles With: Parking Aid Camera / Description and Operation - Parking Aid - Overview

Overview

The rear parking aid camera system visually aids the driver while reversing or reverse parking the vehicle. When reverse gear is selected, the rear parking aid camera image is displayed on FDIM . The camera system has features that provide fixed and active guideline overlays on the video image to assist the driver in aligning the vehicle, a manual zoom and a visual park aid alert function that works with the rear audible parking aid system to visually highlight a zone in the video image where an object has been detected. The rear parking aid camera communicates with the BCM through a LIN circuit. Refer to the Owner's Literature for additional information on operating the rear parking aid camera system features.

    Description and Operation - Parking Aid - Component Location

    C..

    Description and Operation - Parking Aid - System Operation and Component Description

    System Operation Rear Parking Aid Camera System Diagram Item Description 1 HS-CAN1 2 LIN 3 HS-CAN2 4 MS-CAN 5 HS-CAN3 6 Rear Parking Aid Camera 7 video signal 8 TRM 9 IPC 10 BCM 11 GWM ..

    Other information:

    Ford Ecosport 2014-2026 Service and Repair Manual: Diagnosis and Testing - Climate Control System - Vehicles With: Electronic Automatic Temperature Control (EATC)


    DTC Charts DTC Chart: Powertrain Control Module (PCM) Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. For information about these practices, REFER to: Diagnostic Methods (100-00 General Information, Description and Operation). Network Diagnostic Trouble Codes (DTCs) (U-codes) are often a result of intermittent conce..

    Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - Selector Lever


    Removal NOTE: Removal steps in this procedure may contain installation details. Remove the floor console. Refer to: Floor Console (501-12 Instrument Panel and Console, Removal and Installation). Detach the wiring harness retainers from the selector lever. Disconnect the selector lever electrical conne..

    Categories

    Removal and Installation - Oil Pressure Switch

    Materials

    Name Specification Motorcraft® Thread Sealant with PTFE
    TA-24-B WSK-M2G350-A2
     

    Removal

    NOTE: Removal steps in this procedure may contain installation details.

    With the vehicle in NEUTRAL, position it on a hoist.
    Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
    If equipped, remove the bolts and the underbody shield.

    read more

    Copyright © 2026 www.foecosport2.com