Ford Ecosport: Parking Aid / Description and Operation - Parking Aid - Component Location
Ford Ecosport 2014-2026 Service and Repair Manual / Instrumentation and Warning Systems / Parking Aid / Description and Operation - Parking Aid - Component Location
Parking Aid, Audible - Component Location
| Item | Description |
|---|---|
| 1 | Parking aid sensors, front (if equipped) |
| 2 | Parking aid disable switch |
| 3 | Rear door speakers (only left speaker shown, part of audio system) |
| 4 | Parking aid sensors, rear |
| 5 | PAM |
| 6 | Front door speaker (only right speaker shown, part of audio system) |
Description and Operation - Parking Aid - Overview
Parking Aid
The
available parking aid features are dependant on the vehicle trim level
and options selected. The possible audio parking aid configurations are
as follows:
Rear parking aid
Front and rear parking aid
The
parking aid system alerts the driver to obstacles when traveling at
speeds less than 5 km/h (3 mph)...
Other information:
Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - Back Panel
Special Tool(s) / General Equipment Resistance Spotwelding Equipment 8 mm Drill Bit MIG/MAG Welding Equipment Spot Weld Drill Bit Locking Pliers Materials Name Specification Seam SealerTA-2-B, 3M™ 08308, LORD Fusor® 803DTM - Removal NOTE: The back panel is constructed of mild steel and High-Strength low ..
Ford Ecosport 2014-2026 Service and Repair Manual: Diagnosis and Testing - Air/Fuel Ratio
Diagnostic Trouble Code (DTC) Chart Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation). Module DTC Description Action PCM P0030:00 HO2S Heater Control Circuit (Bank 1, Sensor 1): No Sub Type Information GO to Pinpoint Test D..
Categories
- Manuals Home
- 2nd Gen Ford Ecosport Service Manual (2014 - 2026)
- Removal and Installation - Blower Motor
- Removal and Installation - Roof Rail
- Removal and Installation - Rear Bumper
- Removal and Installation - Evaporative Emission Canister Purge Valve
- General Procedures - Transmission Fluid Level Check
Removal and Installation - Oil Pressure Switch
Materials
Name Specification Motorcraft® Thread Sealant with PTFETA-24-B WSK-M2G350-A2
Removal
NOTE: Removal steps in this procedure may contain installation details.
With the vehicle in NEUTRAL, position it on a hoist.Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
If equipped, remove the bolts and the underbody shield.
Copyright © 2026 www.foecosport2.com