Ford Ecosport Owners and Service Manuals

Ford Ecosport: Engine Cooling - 2.0L Duratec-HE (129kW/175PS) / Specifications


  Original Fluids


Name Fill Capacity
  Material: Motorcraft® Orange Concentrated Antifreeze/Coolant / VC-3-B (WSS-M97B44-D)   6.55  qt ( 6.2  L)
  Material: Motorcraft® Orange Prediluted Antifreeze/Coolant / VC-3DIL-B (WSS-M97B44-D2)   6.55  qt ( 6.2  L)

  Service Fluids and Materials


Name Fill Capacity
  Material: Motorcraft® Yellow Concentrated Antifreeze/Coolant / VC-13-G (WSS-M97B57-A1)   6.55  qt ( 6.2  L)
  Material: Motorcraft® Yellow Prediluted Antifreeze/Coolant / VC-13DL-G (WSS-M97B57-A2)   6.55  qt ( 6.2  L)
  Material: Motorcraft® Premium Cooling System Flush / VC-1 (ESR-M14P7-A)

  Antifreeze


Percent Antifreeze/Coolant to Distilled Water Freeze Protection
42/58 -14.8 °F ( -26 °C)
58/42 (Extreme Cold Climates) -57.9 °F ( -50 °C)

  Cooling System Pressure Specification


Description Pressure kpa (psi)
Radiator pressure test 138 (20)
Degas bottle cap release pressure 130 to 150 (18 to 21)

    Engine Cooling - 2.0L Duratec-HE (129kW/175PS)

    ..

    Description and Operation - Engine Cooling - Component Location

    Item Description 1 Coolant outlet connector 2 Cooling fan motor and shroud 3 Radiator 4 Coolant pump pulley 5 Degas bottle Item Description 1 Coolant pump 2 Thermostat housing ..

    Other information:

    Ford Ecosport 2014-2026 Service and Repair Manual: Description and Operation - Acceleration Control - Overview


    Acceleration Control The acceleration controls consist of the accelerator pedal and sensor assembly. The throttle is controlled by an APP sensor on the accelerator pedal assembly. The APP sensor sends a signal to the PCM in response to throttle pedal movements initiated by the driver. The PCM sends a signal to the electronic throttle control which increases and decreases throttle posit..

    Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - Evaporator Inlet and Outlet Manifold - 2.0L Duratec-HE (129kW/175PS)


    Removal NOTICE: During the removal of components, cap, tape or otherwise appropriately protect all openings to prevent the ingress of dirt or other contamination. Remove protective materials prior to installation. NOTE: Removal steps in this procedure may contain installation details. Recover the refrigerant. Refer to: Air Conditioning (A/C) System Recovery, E..

    Categories

    Removal and Installation - Wheel Knuckle Bushing

    Special Tool(s) / General Equipment

    Hydraulic Press

    Removal

    NOTE: Removal steps in this procedure may contain installation details.

    Remove the wheel knuckle.
    Refer to: Wheel Knuckle - Vehicles With: Rear Drum Brakes (204-02B Rear Suspension - AWD, Removal and Installation).
    Remove the rear toe adjustment retainers and remove the wheel knuckle mounting bracket.
    Torque:
      Stage 1:  177 lb.in (20 Nm)
      Stage 2:  76 lb.ft (103 Nm)

    read more

    Copyright © 2026 www.foecosport2.com