Ford Ecosport: Power Steering / Removal and Installation - Steering Gear Boot

Ford Ecosport 2014-2026 Service and Repair Manual / Steering System / Power Steering / Removal and Installation - Steering Gear Boot

Special Tool(s) / General Equipment

204-169
Clamping Tool, Boot Retaining Clamp

Removal

NOTE: Removal steps in this procedure may contain installation details.

Remove the tie rod end.
Refer to: Tie Rod End (211-02 Power Steering, Removal and Installation).

Remove the tie rod end jamb nut.

Remove and discard the steering gear boot clamps and remove the steering gear boot.

Installation

NOTE: The seal is to be reused unless damaged.

NOTE: Make sure that the seal is correctly located.
Inspect the steering gear boot inner seal.

Install the steering gear boot.

Install the steering gear boot inner clamp.
Use Special Service Tool: 204-169 Clamping Tool, Boot Retaining Clamp.

Install the steering gear boot outer clamp.

Install the tie rod end jamb nut.

Install the tie rod end.
Refer to: Tie Rod End (211-02 Power Steering, Removal and Installation).

Removal and Installation - Steering Gear

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the front subframe. Refer to: Front Subframe (502-00 Uni-Body, Subframe and Mounting System, Removal and Installation)...

Removal and Installation - Tie Rod

Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: If servicing the RH (right-hand) tie rod, both bellows boots must be removed...

Other information:

Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - Rear Door Trim Panel

Special Tool(s) / General Equipment Interior Trim Remover Removal NOTE: LH shown, RH similar. Release the clips and remove the rear door sail panel. Use the General Equipment: Interior Trim Remover Remove the interior rear door handle screw cover...

Ford Ecosport 2014-2026 Service and Repair Manual: General Procedures - Exhaust Manifold Cleaning and Inspection

Special Tool(s) / General Equipment Feeler Gauge Cleaning Clean the exhaust manifold using a suitable solvent. Use a plastic scraping tool to clean the gasket sealing surfaces. Inspection NOTE: New exhaust manifold gaskets, studs, nuts and/or bolts must be installed when an exhaust manifold is serviced...

Description and Operation - Health and Safety Precautions

General Service Warnings

Review carefully the information below before beginning any repair. Following these warnings is a list of specific system warnings that must be reviewed before beginning work on any listed system.

WARNING: Wear eye and ear protection when servicing a vehicle. Failure to follow this instruction may result in serious personal injury.