Ford Ecosport: Power Steering / Removal and Installation - Steering Gear
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the front subframe.
Refer to: Front Subframe (502-00 Uni-Body, Subframe and Mounting System, Removal and Installation).
-
NOTE:
This step is only necessary when installing a new component.
Remove the front stabilizer bracket bolts.
Torque:
37 lb.ft (50 Nm)
-
NOTE:
This step is only necessary when installing a new component.
Remove and discard the steering gear mounting bolts and remove the steering gear.
Torque:
66 lb.ft (90 Nm)
Installation
-
To install, reverse the removal procedure.
Special Tool(s) /
General Equipment
204-169Clamping Tool, Boot Retaining Clamp
Removal
NOTE:
Removal steps in this procedure may contain installation details...
Other information:
Special Tool(s) /
General Equipment
100-001
(T50T-100-A)
Slide Hammer
205-153
(T80T-4000-W)
Handle
205-990Installer, Axle SealTKIT-2012A-FLTKIT-2012A-ROW
303-D011
(D80L-100-G)
Actuator Pin (Dia 3/16)
303-D019
(D80L-100-Q)
Collet, 3/4 to 7/8
307-003
(T57L-500-B)
Holding Fixture, Transmission
307-091Han..
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Using a non-marring tool position the media hub out.
Use the General Equipment: Interior Trim Remover
Disconnect the electrical connectors and remove the media hub.
..