Ford Ecosport Owners and Service Manuals

Ford Ecosport: Electronic Engine Controls - 2.0L Duratec-HE (129kW/175PS) / Removal and Installation - Knock Sensor (KS)

Removal

NOTE: Removal steps in this procedure may contain installation details.

  1. Remove the intake manifold.
    Refer to: Intake Manifold (303-01C Engine - 2.0L Duratec-HE (129kW/175PS), Removal and Installation).
  1. NOTE: Note the position of the components before removal.

    NOTE: Make sure that the components are installed to the position noted before removal.

    Remove the bolts and the KS .
    Torque: 177 lb.in (20 Nm)

Installation

  1. To install, reverse the removal procedure.

    Removal and Installation - Heated Oxygen Sensor (HO2S)

    S..

    Removal and Installation - Mass Air Flow (MAF) Sensor

    Removal NOTE: Removal steps in this procedure may contain installation details. Disconnect and remove the MAF sensor. Torque: 18 lb...

    Other information:

    Ford Ecosport 2014-2026 Service and Repair Manual: General Procedures - Headlamp Adjustment


    Adjustment NOTE: If the flash video link does not load or is incompatible with your browser, a .wmv version of the video can be accessed at: http://www.fordservicecontent.com/Ford_Content/videos/FusionHeadlampAdj2.wmv Click on the link above to view video...

    Ford Ecosport 2014-2026 Service and Repair Manual: Diagnosis and Testing - Speed Control


    Refer to Wiring Diagrams Section 310-03 for schematic and connector information. General Equipment Ford diagnostic equipment Inspection and Verification Verify the customer concern by operating the system. Visually inspect for obvious signs of mechanical or electrical damage...

    Categories

    Removal and Installation - Wheel Knuckle Bushing

    Special Tool(s) / General Equipment

    Hydraulic Press

    Removal

    NOTE: Removal steps in this procedure may contain installation details.

    Remove the wheel knuckle.
    Refer to: Wheel Knuckle - Vehicles With: Rear Drum Brakes (204-02B Rear Suspension - AWD, Removal and Installation).
    Remove the rear toe adjustment retainers and remove the wheel knuckle mounting bracket.
    Torque:
      Stage 1:  177 lb.in (20 Nm)
      Stage 2:  76 lb.ft (103 Nm)

    read more

    Copyright © 2026 www.foecosport2.com