Ford Ecosport: Uni-Body, Subframe and Mounting System / Description and Operation - Frame Assembly - Overview

Ford Ecosport 2014-2026 Service and Repair Manual / Frame and Mounting / Uni-Body, Subframe and Mounting System / Description and Operation - Frame Assembly - Overview

Overview

The front subframe is bolted to the body and is used to:

aid in structural support.
provide mounting surfaces for the steering gear.
provide mounting surfaces for the front suspension lower control arms, the transmission roll restrictor and for the front stabilizer bar.

For body dimension specifications,
Refer to: Specifications (501-25 Body Repairs - General Information, Specifications).

Uni-Body, Subframe and Mounting System

Removal and Installation - Front Subframe

Special Tool(s) / General Equipment Tie Rod End Remover Transmission Jack Removal All vehicles NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems...

Other information:

Ford Ecosport 2014-2026 Service and Repair Manual: Diagnosis and Testing - Pinpoint Test - DTC: P, Vehicles With: Rear Seat Side Airbag

B00C5:11, B00C5:12, B00C5:13, B00C5:1D Refer to Wiring Diagrams Cell 46 for schematic and connector information. Normal Operation and Fault Conditions The RCM continuously monitors the passenger seat position sensor circuits for the following faults: Open circuit Short to voltage Short to ground Current out of range Faulted passenger s..

Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - Flexplate

Special Tool(s) / General Equipment 303-103 (T74P-6375-A) Holding Tool, FlywheelT74P-77000-ATKIT-2009TC-F Removal Remove the automatic transmission. Refer to: Transmission (307-01B) . Install Special Service Tool: 303-103 (T74P-6375-A) Holding Tool, Flywheel. Remove the bolts and the flexpl..

Removal and Installation - Brake Disc Shield

Removal

NOTE: Removal steps in this procedure may contain installation details.

Remove the brake disc.
Refer to: Brake Disc (206-03 Front Disc Brake, Removal and Installation).
Remove the bolts and brake disc.
Torque: 80 lb.in (9 Nm)