Ford Ecosport: Engine Cooling - 2.0L Duratec-HE (129kW/175PS) / Removal and Installation - Heater Hoses

Ford Ecosport 2014-2026 Service and Repair Manual / Engine / Engine Cooling - 2.0L Duratec-HE (129kW/175PS) / Removal and Installation - Heater Hoses

Removal

NOTE: Removal steps in this procedure may contain installation details.

Remove the engine appearance cover.

Remove the battery tray.
Refer to: Battery Tray (414-01 Battery, Mounting and Cables, Removal and Installation).

Remove the coolant hose.
Refer to: Coolant Hose (303-03C Engine Cooling - 2.0L Duratec-HE (129kW/175PS), General Procedures).

Installation

To install, reverse the removal procedure.

Removal and Installation - Degas Bottle

Special Tool(s) / General Equipment Fluid Suction Gun Hose Clamp Remover/Installer Locking Pliers Materials Name Specification Motorcraft® Orange Prediluted Antifreeze/CoolantVC-3DIL-B WSS-M97B44-D2 Removal WARNING: Always allow the engine to cool before opening the cooling system...

Removal and Installation - Radiator

Special Tool(s) / General Equipment Hose Clamp Remover/Installer Removal NOTE: Removal steps in this procedure may contain installation details...

Other information:

Ford Ecosport 2014-2026 Service and Repair Manual: Diagnosis and Testing - Pinpoint Test - DTC: H, Vehicles With: Rear Seat Side Airbag

B0052:11, B0052:12, B0052:13, B0052:1D Refer to Wiring Diagrams Cell 46 for schematic and connector information. Normal Operation and Fault Conditions The RCM continuously monitors the passenger seatbelt buckle sensor circuits for the following faults: Open circuit Short to voltage Short to ground Current out of range Faulted passenger..

Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - Fuel Rail Pressure (FRP) Sensor

Materials Name Specification Engine Oil - SAE 5W-20 - Synthetic Blend Motor OilXO-5W20-Q1SP WSS-M2C945-B1 Removal Release the fuel system pressure. Refer to: Fuel System Pressure Release (310-00C Fuel System - General Information - 2.0L Duratec-HE (129kW/175PS), General Procedures). Remove the intake manifold. Refer..

Removal and Installation - Variable Camshaft Timing (VCT) Unit

Removal

NOTICE: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces, that enters the oil passages, coolant passages or the oil pan can cause engine failure.

Remove the timing chain.
Refer to: Timing Chain (303-01C Engine - 2.0L Duratec-HE (129kW/175PS), Removal and Installation).
Remove the bolts and VCT units.
Discard the bolts.