Ford Ecosport: Instrument Panel and Console / Removal and Installation - Glove Compartment

Ford Ecosport 2014-2026 Service and Repair Manual / Body and Paint / Instrument Panel and Console / Removal and Installation - Glove Compartment

Removal

Open the glove compartment.

Release the golve compartment stops and remove the dampener.

Fully lower and remove the glove compartment.

Installation

To install, reverse the removal procedure.

Removal and Installation - Floor Console

Special Tool(s) / General Equipment Interior Trim Remover Removal NOTE: Removal steps in this procedure may contain installation details...

Removal and Installation - Instrument Panel

Special Tool(s) / General Equipment Locking Pliers Removal NOTE: Removal steps in this procedure may contain installation details...

Other information:

Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - Rear Door

Special Tool(s) / General Equipment Door Lift Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: LH side shown, RH side similar. Open the rear door. Remove the check arm bolt...

Ford Ecosport 2014-2026 Service and Repair Manual: General Procedures - Parking Aid Camera Initialization

NOTE: On vehicles equipped with Trailer Reverse Guidance (TRG) complete this procedure and also perform the Trailer Reverse Guidance camera alignment. Using a scan tool select the controlling module for the parking aid camera(s). Refer to the wiring diagram to identify the camera controlling module...

Removal and Installation - Variable Camshaft Timing (VCT) Unit

Removal

NOTICE: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces, that enters the oil passages, coolant passages or the oil pan can cause engine failure.

Remove the timing chain.
Refer to: Timing Chain (303-01C Engine - 2.0L Duratec-HE (129kW/175PS), Removal and Installation).
Remove the bolts and VCT units.
Discard the bolts.