Ford Ecosport: Seatbelt Systems / Removal and Installation - Front Seatbelt Buckle
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
Driver seat shown, passenger seat similar.
-
Remove the front seat.
Refer to: Front Seat (501-10A Front Seats, Removal and Installation).
-
Detach and disconnect the front seatbelt buckle and position the wiring harness aside.
-
Remove the front seatbelt buckle.
-
Detach the pin-type retainers.
-
Remove the bolt.
Torque:
33 lb.ft (45 Nm)
Installation
NOTE:
During installation, make sure the seatbelt webbing is not
twisted and the seatbelts and buckles are accessible to the occupants.
-
To install, reverse the removal procedure.
-
Check the seatbelt system for correct operation.
Refer to: Seatbelt Systems (501-20A Seatbelt Systems, Diagnosis and Testing).
Adjustment
NOTE:
Typical D-ring shown, others similar.
If required, remove the necessary trim panel(s).
Fold the seatbelt as indicated...
Removal
WARNING:
The following procedure prescribes critical repair steps
required for correct restraint system operation during a crash...
Other information:
Special Tool(s) /
General Equipment
307-566Retainer, Torque ConverterTKIT-2006C-FFMFLMTKIT-2006C-LMTKIT-2006C-ROW
Magnetic Socket
Floor Crane
Adjustable Mounting Arm
Oil Drain Equipment
Cable Ties
Hose Clamp Remover/Installer
Powertrain Jack
Wooden Block
All vehicles
With the vehicle in NEUTRAL, ..
B0070:11, B0070:12, B0070:13, B0070:1A
Refer to Wiring Diagrams Cell 46 for schematic and connector information.
Normal Operation and Fault Conditions
The RCM continuously monitors the driver seatbelt anchor pretensioner circuits for the following faults:
Resistance out of range
Unexpected voltage
Short to ground
Faulted driver seatbelt anchor pre..