Ford Ecosport: Exterior Trim and Ornamentation / Removal and Installation - Front Fender Moulding

Ford Ecosport 2014-2026 Service and Repair Manual / Body and Paint / Exterior Trim and Ornamentation / Removal and Installation - Front Fender Moulding

Removal

NOTE: Removal steps in this procedure may contain installation details.

NOTE: LH side shown, RH side similar.

With the vehicle in NEUTRAL, position it on a hoist.
Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).

NOTICE: Only use moderate force.
Remove the pushpin retainers and remove the front fender moulding.

Installation

To install, reverse the removal procedure.

Removal and Installation - Front Door Upper Moulding

Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: LH side shown, RH side similar. Lower the door window glass...

Removal and Installation - Liftgate Moulding

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the liftgate trim panel. Refer to: Liftgate Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation)...

Other information:

Ford Ecosport 2014-2026 Service and Repair Manual: Diagnosis and Testing - Noise, Vibration and Harshness (NVH)

Special Tool(s) Vehicle Communication & Measurement Module (VCMM™) Base Kit 164-R9822 / 164-R9823 EngineEAR107-R2100Chassis EarsJSP97170 Squeak And Rattle Kit164-R4900 Ultrasonic Diagnostic ToolTRATP-9367 Diagnostic Theory The shortest route to an accurate diagnosis results from: System kn..

Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - Crankshaft Pulley

Special Tool(s) / General Equipment 303-1521Alignment Tool, Crankshaft Position SensorTKIT-2010C-FLM 303-1686Holding Tool, Camshaft 303-1689Holding Tool, Crank Damper 303-507Timing Peg, Crankshaft TDCTKIT-2001N-FLMTKIT-2001N-ROW Trolley Jack Wooden Block Removal NOTICE: Do not loosen or remove the crankshaft pulley bo..

Removal and Installation - Steering Column Shaft

Removal

NOTE: Removal steps in this procedure may contain installation details.

NOTICE: Do not allow the steering column to rotate while the steering column shaft is disconnected or damage to the steering column internal sensor may result.

NOTE: Use a steering wheel holding device (such as Hunter® 28-75-1 or equivalent)

Hold the steering wheel in the straight-ahead position.