Ford Ecosport: Automatic Transmission External Controls / Removal and Installation - Downshift Paddle Switch

Ford Ecosport 2014-2026 Service and Repair Manual / Automatic Transmission / Automatic Transmission External Controls / Removal and Installation - Downshift Paddle Switch

Removal

NOTE: Removal steps in this procedure may contain installation details.

Remove the RH steering wheel multifunction switch.
Refer to: Steering Wheel Multifunction Switch (211-05 Steering Wheel and Column Electrical Components, Removal and Installation).

Disconnect the downshift paddle switch electrical connector.

Remove the bolt and the downshift paddle switch.

Installation

To install, reverse the removal procedure.

General Procedures - Selector Lever Cable Adjustment - 6-Speed Automatic Transmission – 6F35

Adjustment Apply the parking brake. Position the selector lever in D . Remove the air cleaner...

Removal and Installation - Selector Lever

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the floor console. Refer to: Floor Console (501-12 Instrument Panel and Console, Removal and Installation)...

Other information:

Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - Rear Door Check Arm

Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: LH side shown, RH side similar. Open the rear door. Remove the check arm bolt. Torque: 17 lb...

Ford Ecosport 2014-2026 Service and Repair Manual: Diagnosis and Testing - Pinpoint Test - DTC: B, Vehicles With: Rear Seat Side Airbag

B0002:11, B0002:12, B0002:13 and B0002:1A Refer to Wiring Diagrams Cell 46 for schematic and connector information. Normal Operation and Fault Conditions The RCM continuously monitors the driver airbag stage 2 circuits for the following faults: Resistance out of range Unexpected voltage Short to ground Faulted driver airbag If a fault is d..

Removal and Installation - Front Brake Flexible Hose

Removal

Remove the wheel and tire.
Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation).

Remove the brake flexible hose bracket bolt.
Disconnect the brake tube fitting and remove the brake hose clip.
Loosen the brake hose fitting and remove the brake flexible hose.