Ford Ecosport: Exterior Trim and Ornamentation / Removal and Installation - D-Pillar Moulding
Removal
NOTE:
LH side shown, RH side similar.
-
Carefully open the liftgate.
-
Remove the D-pillar moulding screws and remove the D-pillar moulding.
Installation
-
NOTE:
Make sure that a new component is installed.
Install the D-pillar moulding.
Torque:
15 lb.in (1.7 Nm)
-
Carefully close the liftgate.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH side similar.
Lower the door window glass...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH side similar.
NOTICE:
Only use moderate force...
Other information:
Overview
Multiplexing
is a method of sending 2 or more signals simultaneously over a single
circuit. Multiplexing allows 2 or more electronic modules (nodes) to
communicate over a twisted wire pair [data (+) and data (-)] network.
The information or messages that can be communicated on these wires
consists of commands, status or data...
Adhesives
NOTE:
The following illustrations are examples of structural adhesive application and are not all inclusive.
Upper Cowl Panel to Lower Cowl Panel
Front Structure to A-Pillar
The
correct adhesive bonding is essential to repairing the vehicle
correctly...