Ford Ecosport: Module Communications Network / Description and Operation - Communications Network - Overview
Overview
Multiplexing is a method of sending 2 or more signals simultaneously over a single circuit. Multiplexing allows 2 or more electronic modules (nodes) to communicate over a twisted wire pair [data (+) and data (-)] network. The information or messages that can be communicated on these wires consists of commands, status or data. Multiplexing reduces the weight of the vehicle by reducing the number of redundant components and electrical wiring.
The vehicle has 2 module communication networks connected to the DLC , located under the instrument panel. The communication networks are:
- DIAG 1
- DIAG 2
The vehicle has 5 communication networks that do not communicate directly with the diagnostic scan tool. The GWM translates the messages on these 5 networks and transfers the signals to the DIAG 1 and DIAG 2 circuits at the DLC . Messages communicated on the HS-CAN1 are communicated to the DIAG 1 connection, all other networks are translated to the DIAG 2 connection at the remote DLC . The communication networks are:
- HS-CAN1
- HS-CAN2
- HS-CAN3
- HS-CAN4
- MS-CAN
Description and Operation - Communications Network - System Operation and Component Description
System Operation
System Operation
*.sttxt {
visibility: hidden;
}
*.stcallout {
visibility: visible;
}
E356703
..
Other information:
Ford Ecosport 2014-2025 Service and Repair Manual: Diagnosis and Testing - Pinpoint Test - DTC: AA, Vehicles With: Rear Seat Side Airbag
B1413:11, B1413:12, B1413:13, B1413:96 Refer to Wiring Diagrams Cell 46 for schematic and connector information. Normal Operation and Fault Conditions The RCM monitors the front impact severity sensor circuits for the following faults: Open circuit Short to voltage Short to ground Faulted front impact severity sensor If a fault is detec..
Ford Ecosport 2014-2025 Service and Repair Manual: Removal and Installation - Rear Seat Cushion Cover
Special Tool(s) / General Equipment Hog Ring Plier Removal NOTE: 40 percent rear seat shown, 60 percent similar. Remove the rear seat cushion. Refer to: Rear Seat Cushion (501-10B Rear Seats, Removal and Installation). Detach the J-clips and remove the rear seat cushion cover and foam as an assembly. ..
Categories
- Manuals Home
- 2nd Gen Ford Ecosport Service Manual (2014 - 2025)
- Removal and Installation - Starter Motor
- Diagnosis and Testing - Powertrain Control Module (PCM) Input and Output Controls
- Body and Paint
- Description and Operation - Jacking and Lifting - Overview
- General Procedures - Transmission Fluid Level Check
Description and Operation - Health and Safety Precautions
General Service Warnings
Review carefully the information below before beginning any repair. Following these warnings is a list of specific system warnings that must be reviewed before beginning work on any listed system.
WARNING:
Wear eye and ear protection when servicing a vehicle.
Failure to follow this instruction may result in serious personal
injury.
