Ford Ecosport: Information and Entertainment System - General Information / Removal and Installation - Antenna Isolator Module
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the liftgate trim panel.
Refer to: Liftgate Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
-
Disconnect the electrical connector, remove the bolt and the antenna isolator module.
Torque:
93 lb.in (10.5 Nm)
Installation
-
To install, reverse the removal procedure.
Removal
Remove the A-pillar trim panel.
Refer to: A-Pillar Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation)...
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
Removal steps in this procedure may contain installation details...
Other information:
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
If installing a new module, it is necessary to
upload the module configuration information to the scan tool prior to
removing the module...
Removal
NOTE:
LH side shown, RH side similar.
Remove the access plug and the exterior rear door handle retaining screw.
Remove the access plug from the rear door.
Remove the exterior rear door handle retaining screw...