Ford Ecosport: Roof Opening Panel / Removal and Installation - Air Deflector
Special Tool(s) /
General Equipment
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Place the roof opening panel glass in the fully OPEN position.
-
NOTE:
LH side shown, RH side similar.
On both sides.
Release the air deflector locking tab.
-
Depress the spring steel locating tab downward with a flat-bladed screwdriver.
Use the General Equipment: Flat-Bladed Screwdriver
-
Push the air deflector toward the rear of the vehicle.
-
Remove the air deflector assembly.
-
Tilt the air deflector assembly upward.
-
Pull forward to remove air deflector assembly.
Installation
-
NOTE:
Make sure the air deflector locating tabs are firmly located in place.
To install, reverse the removal procedure.
-
Initialize the power roof opening panel.
Refer to: Power Roof Opening Panel Initialization (501-17 Roof Opening Panel, General Procedures).
Adjustment
Remove the overhead console.
Refer to: Overhead Console (501-12 Instrument Panel and Console, Removal and Installation).
Rotate the retainer counterclockwise to open the roof opening panel manually...
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
Removal steps in this procedure may contain installation details...
Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH side similar.
With the vehicle in NEUTRAL, position it on a hoist.
Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation)...
B1414:11, B1414:12, B1414:13, B1414:96, B1419:11, B1419:12, B1419:13, B1419:96
Refer to Wiring Diagrams Cell 46 for schematic and connector information.
Normal Operation and Fault Conditions
The RCM monitors the driver front door and passenger C-pillar side impact sensor circuits for the following faults:
Open circuit
Short to voltage
Short to ground
..