Ford Ecosport Owners and Service Manuals

Ford Ecosport: Roof Opening Panel / General Procedures - Roof Opening Panel Alignment

Ford Ecosport 2014-2026 Service and Repair Manual / Body and Paint / Roof Opening Panel / General Procedures - Roof Opening Panel Alignment

Adjustment

NOTE: The front sliding glass panel initialization procedure must be done when repairs are carried out on the roof opening panel system, including: any time the roof opening panel motor has been removed, the roof opening panel glass has been removed or adjusted, or if the roof opening panel frame has been removed.

  1. Fully close the roof opening panel.
  1. Measure the front and rear of the roof opening panel glass to roof clearances as shown.
  1. If adjustment is needed, fully open the roof opening panel shield.
  1. Adjust the roof opening panel glass.

    1. NOTE: LH side shown, RH side similar.

      On both sides, loosen the retainers to adjust the roof opening panel glass.
      Torque: 28 lb.in (3.2 Nm)
    1. Adjust the roof opening panel glass as necessary.
  1. If any adjustment was made, initialize the roof opening panel glass.
    Refer to: Power Roof Opening Panel Initialization (501-17 Roof Opening Panel, General Procedures).

    Diagnosis and Testing - Roof Opening Panel

    The roof opening panel motor must be initialized when repairs are carried out on any part of the roof opening panel system or when the roof opening panel motor, glass, assembly, or air deflector has been removed or replaced for any reason...

    General Procedures - Power Roof Opening Panel Initialization

    Initialization NOTE: Until the initialization procedure is complete, the one-touch open and one-touch close function is disabled. NOTE: An initialization procedure that was interrupted or not completed can be started again after cycling the ignition from ON to OFF and back to ON again...

    Other information:

    Ford Ecosport 2014-2026 Service and Repair Manual: Disassembly and Assembly of Subassemblies - Cylinder Head


    Special Tool(s) / General Equipment 303-1249Valve Spring CompressorTKIT-2006UF-FLMTKIT-2006UF-ROW 303-1567Sizer, Teflon SealTKIT-2010C-FLM 303-300 (T87C-6565-A) Set, Valve Spring CompressorTKIT-1988-FESTIVAT88C-1000-STTKIT-1988-TRACERTKIT-2009TC-F 303-350 (T89P-6565-A) Compressor, Valve SpringTKIT-1990-LMHTKIT-1989-FTKIT-1989-FMTKIT-1989-FLM ..

    Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - Front Door Lock Cylinder


    Removal NOTE: LHD shown, RHD similar. NOTE: Repair individual door lock cylinders by discarding the inoperative door lock cylinder and building a new door lock cylinder using the appropriate lock repair service kit. The lock repair service kit includes a detailed instruction sheet to build the new lock to match the key cut pattern for the vehicle, thus allowing for single p..

    Categories

    Removal and Installation - Oil Pressure Switch

    Materials

    Name Specification Motorcraft® Thread Sealant with PTFE
    TA-24-B WSK-M2G350-A2
     

    Removal

    NOTE: Removal steps in this procedure may contain installation details.

    With the vehicle in NEUTRAL, position it on a hoist.
    Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
    If equipped, remove the bolts and the underbody shield.

    read more

    Copyright © 2026 www.foecosport2.com