Ford Ecosport: Roof Opening Panel / Description and Operation - Roof Opening Panel - Overview
Overview
The roof opening panel consists of the following:
- Air deflector
- Roof opening panel frame
- Roof opening panel glass
- Roof opening panel motor
- Roof opening panel shield
- Roof opening panel drain hoses
- Roof opening panel control switch
- Trough assembly
The
roof opening panel motor must be initialized when repairs are carried
out on the roof opening panel system, including: any time the roof
opening panel motor has been removed, the roof opening panel glass has
been removed or adjusted , or if the roof opening panel frame has been
removed.
Refer to: Power Roof Opening Panel Initialization (501-17 Roof Opening Panel, General Procedures).
The accessory delay relay, located in the BCM , that provides
voltage for the operation of the power windows and the roof opening
panel.
Refer to: Glass, Frames and Mechanisms (501-11 Glass, Frames and Mechanisms, Diagnosis and Testing).
The roof opening panel is an electronically operated glass panel with a one-touch open feature. The roof opening panel assembly uses an integrated module and motor to operate the roof opening panel.
Specifications
Specifications
Item
Specification
Sliding glass panel to roof flushness, front
-0...
Description and Operation - Roof Opening Panel - System Operation and Component Description
System Operation
Roof Opening Operation
The
roof opening panel assembly uses an integrated motor and module to
operate the roof opening panel...
Other information:
Ford Ecosport 2014-2025 Service and Repair Manual: Diagnosis and Testing - Pinpoint Test - DTC: E, Vehicles With: Rear Seat Side Airbag
B0011:11, B0011:12, B0011:13, B0011:1A Refer to Wiring Diagrams Cell 46 for schematic and connector information. Normal Operation and Fault Conditions The RCM continuously monitors the passenger airbag stage 2 circuits for the following faults: Resistance out of range Unexpected voltage Short to ground Faulted passenger airbag If a fault i..
Ford Ecosport 2014-2025 Service and Repair Manual: Removal and Installation - Rear Door Moulding
Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: LH side shown, RH side similar. NOTICE: Only use moderate force. Using a non-marring trim removal tool, disengage the retainer clips, release adhesive tape and remove moulding. Installation To install, reverse the removal..
Categories
- Manuals Home
- 2nd Gen Ford Ecosport Service Manual (2014 - 2025)
- Description and Operation - Evaporative Emissions - System Operation and Component Description
- Removal and Installation - Fuel Pump and Sender Unit
- General Procedures - Transmission Fluid Level Check
- General Procedures - Battery Charging
- Diagnosis and Testing - Evaporative Emissions
Removal and Installation - Front Brake Flexible Hose
Removal
Remove the wheel and tire.Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation).
Remove the brake flexible hose bracket bolt.
Disconnect the brake tube fitting and remove the brake hose clip.
Loosen the brake hose fitting and remove the brake flexible hose.
