Ford Ecosport: Fuel Charging and Controls - 2.0L Duratec-HE (129kW/175PS) / Description and Operation - Fuel Charging and Controls - Component Location
Ford Ecosport 2014-2025 Service and Repair Manual / Engine / Fuel Charging and Controls - 2.0L Duratec-HE (129kW/175PS) / Description and Operation - Fuel Charging and Controls - Component Location
2.0L Duratec-HE
| Item | Description |
|---|---|
| 1 | Throttle body |
| 2 | Fuel injector |
| 3 | High-pressure fuel pump drive unit |
| 4 | High-pressure fuel pump |
| 5 | Fuel rail |
Fuel Pump Driver Module
| Item | Description |
|---|---|
| 1 | Fuel pump driver module |
Description and Operation - Fuel Charging and Controls - System Operation and Component Description
System Operation
Air Fuel Ratio Imbalance Monitor
The air fuel ratio imbalance monitor is an on board diagnostic strategy designed to monitor the air fuel ratio...
Other information:
Ford Ecosport 2014-2025 Service and Repair Manual: Removal and Installation - Exterior Front Door Handle Reinforcement
Removal NOTE: LH side shown, RH side similar. Remove the front door latch. Refer to: Front Door Latch (501-14 Handles, Locks, Latches and Entry Systems, Removal and Installation). Remove the front door latch from the exterior front door handle reinforcement...
Ford Ecosport 2014-2025 Service and Repair Manual: Diagnosis and Testing - Parking Aid
Diagnostic Trouble Code (DTC) Chart Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation). Module DTC Description Action PAM B1303:13 Park Assist Switch: Circuit Open GO to Pinpoint Test K PAM B1303:9E Park Assist S..
Categories
- Manuals Home
- 2nd Gen Ford Ecosport Service Manual (2014 - 2025)
- Removal and Installation - Fuel Pump and Sender Unit
- Removal and Installation - Evaporative Emission Canister Purge Valve
- Diagnosis and Testing - Body Control Module (BCM)
- Removal and Installation - Front Seat
- General Procedures - Transmission Fluid Level Check
Removal and Installation - Oil Pressure Switch
Materials
Name Specification Motorcraft® Thread Sealant with PTFETA-24-B WSK-M2G350-A2
Removal
NOTE: Removal steps in this procedure may contain installation details.
With the vehicle in NEUTRAL, position it on a hoist.Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
If equipped, remove the bolts and the underbody shield.
Copyright © 2025 www.foecosport2.com