Ford Ecosport Owners and Service Manuals

Ford Ecosport: Engine - 2.0L Duratec-HE (129kW/175PS) / Removal and Installation - Valve Tappets

Ford Ecosport 2014-2025 Service and Repair Manual / Engine / Engine - 2.0L Duratec-HE (129kW/175PS) / Removal and Installation - Valve Tappets

Removal

  1. Remove the camshafts.
    Refer to: Camshaft (303-01C Engine - 2.0L Duratec-HE (129kW/175PS), Removal and Installation).

  1. NOTE: If the camshafts and valve tappets are to be reused, mark the location of the valve tappets to make sure they are assembled in their original positions.

    NOTE: Lubricate the valve tappets with clean engine oil prior to installation.

    Remove the valve tappets.

  1. NOTE: The number on the valve tappets only reflects the digits that follow the decimal. For example, a tappet with the number 0.650 has the thickness of 3.650 mm.

    NOTE: Install new components as necessary.

    Inspect the valve tappets.

Installation

  1. To install, reverse the removal procedure.

    Removal and Installation - Valve Cover

    S..

    Removal and Installation - Variable Camshaft Timing (VCT) Unit

    Removal NOTICE: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces, that enters the oil passages, coolant passages or the oil pan can cause engine failure...

    Other information:

    Ford Ecosport 2014-2025 Service and Repair Manual: Diagnosis and Testing - Pinpoint Test - DTC: AI, Vehicles With: Rear Seat Side Airbag


    U0112:00 Normal Operation and Fault Conditions The RCM uses information contained in messages from the BECMB sent on the HS-CAN2 .   DTC Fault Trigger Conditions   DTC Description Fault Trigger Conditions U0112:00 Lost Communication With Battery Energy Control Module "B": No Su..

    Ford Ecosport 2014-2025 Service and Repair Manual: General Procedures - Cylinder Block Distortion


    Special Tool(s) / General Equipment Feeler Gauge Check NOTE: Refer to the appropriate Section 303-01 for the specification. NOTE: Use a Straightedge that is calibrated by the manufacturer to be flat within 0.005 mm (0.0002 in) per running foot of length, such as Snap-On® GA438A or equivalent. For example, if the Straightedge is 61 cm (24 in) long,..

    Categories

    Removal and Installation - Rear Halfshaft Seal

    Special Tool(s) / General Equipment

    205-153 (T80T-4000-W)
    Handle 205-990
    Installer, Axle Seal
    TKIT-2012A-FL
    TKIT-2012A-ROW

    read more

    Copyright © 2025 www.foecosport2.com