Ford Ecosport: Roof Opening Panel / Removal and Installation - Roof Opening Panel Glass

Ford Ecosport 2014-2026 Service and Repair Manual / Body and Paint / Roof Opening Panel / Removal and Installation - Roof Opening Panel Glass

Removal

NOTE: Removal steps in this procedure may contain installation details.

Place the roof opening panel shield to the fully OPEN position.

Place the roof opening panel glass to the VENT position.

NOTE: LH side shown, RH side similar.
Remove the retainers.
Torque: 28 lb.in (3.2 Nm)

Remove the roof opening panel glass assembly.

Installation

To install, reverse the removal procedure.

Align the roof opening panel glass.
Refer to: Roof Opening Panel Alignment (501-17 Roof Opening Panel, General Procedures).

Initialize the power roof opening panel.
Refer to: Power Roof Opening Panel Initialization (501-17 Roof Opening Panel, General Procedures).

Removal and Installation - Roof Opening Panel Front Drain Hose

Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: LH side shown, RH side similar. Remove the headliner...

Removal and Installation - Roof Opening Panel Motor

Removal NOTE: Removal steps in this procedure may contain installation details. Lower the headliner. Refer to: Headliner - Lowering (501-05 Interior Trim and Ornamentation, Removal and Installation)...

Other information:

Ford Ecosport 2014-2026 Service and Repair Manual: Description and Operation - Fuel Tank and Lines - System Operation and Component Description

System Operation Fuel Systems The fuel system supplies the fuel injectors with clean fuel at a controlled pressure. The PCM controls the fuel pump and monitors the fuel pump circuit. The PCM controls the fuel injector ON/OFF cycle duration and determines the correct timing and amount of fuel delivered...

Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - Rear Side Member Section

Special Tool(s) / General Equipment Resistance Spotwelding Equipment Spherical Cutter Grinder Air Body Saw MIG/MAG Welding Equipment Spot Weld Drill Bit Locking Pliers Materials Name Specification Seam SealerTA-2-B, 3M™ 08308, LORD Fusor® 803DTM - Removal NOTICE: The rear side member reinfo..

Removal and Installation - Brake Disc Shield

Removal

NOTE: Removal steps in this procedure may contain installation details.

Remove the brake disc.
Refer to: Brake Disc (206-03 Front Disc Brake, Removal and Installation).
Remove the bolts and brake disc.
Torque: 80 lb.in (9 Nm)