Ford Ecosport: Rear Seats / Removal and Installation - Rear Seat Cushion Cover
Special Tool(s) /
General Equipment
Removal
NOTE:
40 percent rear seat shown, 60 percent similar.
-
Remove the rear seat cushion.
Refer to: Rear Seat Cushion (501-10B Rear Seats, Removal and Installation).
-
Detach the J-clips and remove the rear seat cushion cover and foam as an assembly.
-
NOTE:
Follow the unique instructions or graphics for this step in installation.
Remove the rear seat cushion cover.
-
Invert the rear seat cushion cover.
-
Remove the hog rings.
Installation
-
To install, reverse the removal procedure.
-
Use the General Equipment: Hog Ring Plier
Removal
WARNING:
The following procedure describes critical repair steps
required for correct seat component installation. Follow all notes and
steps carefully...
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
Removal steps in this procedure may contain installation details...
Other information:
General Equipment
Ford diagnostic equipment
DTC Charts:
Diagnostics
in this manual assume a certain skill level and knowledge of
Ford-specific diagnostic practices. For information about these
practices, REFER to: Diagnostic Methods (100-00 General Information, Description and Operation)...
Special Tool(s) /
General Equipment
205-072Universal Flange Holding Wrench
308-877Installer, Pinion Output SealTKIT-2012A-FLTKIT-2012A-ROW
Puller
Wooden Block
Removal
Remove the transfer case...