Ford Ecosport: Bumpers / Removal and Installation - Rear Bumper

Ford Ecosport 2014-2026 Service and Repair Manual / Body and Paint / Bumpers / Removal and Installation - Rear Bumper

Removal

NOTE: Removal steps in this procedure may contain installation details.

Remove the rear bumper cover.
Refer to: Rear Bumper Cover (501-19 Bumpers, Removal and Installation).

Remove the mounting bolts and the rear bumper.
Torque: 35 lb.ft (47.5 Nm)

Installation

To install, reverse the removal procedure.

Removal and Installation - Front Bumper Cover

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the fender splash shield. Refer to: Fender Splash Shield (501-02 Front End Body Panels, Removal and Installation)...

Removal and Installation - Rear Bumper Cover

Special Tool(s) / General Equipment Long Nose Pliers Removal NOTE: Removal steps in this procedure may contain installation details...

Other information:

Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - Headliner - Lowering

Remove the following items: On both sides. Remove the A-pillar trim panel. Refer to: A-Pillar Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation). On both sides. Remove the B-pillar trim panel...

Ford Ecosport 2014-2026 Service and Repair Manual: Description and Operation - Planetary Assembly

Planetary Gearset Exploded View Item Description 1 Front planetary sun gear and shell assembly 2 Front planetary carrier/rear planetary ring gear assembly 3 Gear - center planetary sun 4 Center planetary carrier/front ring gear assembly ..

Removal and Installation - Variable Camshaft Timing (VCT) Unit

Removal

NOTICE: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces, that enters the oil passages, coolant passages or the oil pan can cause engine failure.

Remove the timing chain.
Refer to: Timing Chain (303-01C Engine - 2.0L Duratec-HE (129kW/175PS), Removal and Installation).
Remove the bolts and VCT units.
Discard the bolts.