Ford Ecosport: Instrument Panel and Console / Removal and Installation - Overhead Console
Special Tool(s) /
General Equipment
Removal
-
Remove the switch panel.
-
Disconnect the electrical connectors.
Use the General Equipment: Interior Trim Remover
-
Remove the screws.
-
Remove the overhead console.
-
Disconnect the electrical connectors.
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the instrument panel.
Refer to: Instrument Panel (501-12 Instrument Panel and Console, Removal and Installation)...
Other information:
Acceleration Control
The acceleration controls consist of the accelerator pedal and sensor assembly.
The throttle is controlled by an APP sensor on the accelerator pedal
assembly. The APP sensor sends a signal to the PCM in response to
throttle pedal movements initiated by the driver. The PCM sends a signal
to the electronic throttle control which increases and decreases
throttle posit..
Removal
NOTE:
LHD shown, RHD similar.
Non-functional lock cylinder
Replace the steering column lock and ignition switch housing.
Refer to: Steering Column Lock and Ignition Switch Housing (211-05
Steering Wheel and Column Electrical Components, Removal and
Installation).
Functional lock cylinder
NOTE:
Repair individual lock cylind..