Ford Ecosport: Perimeter Anti-Theft Alarm / Removal and Installation - Intrusion Sensor

Special Tool(s) / General Equipment

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. 
   Remove the intrusion sensor.
   
   • Disconnect the electrical connectors.
     Use the General Equipment: Interior Trim Remover

Installation

1. To install, reverse the removal procedure.
   

1. NOTE: This step is only necessary when installing a new component.

   Using a diagnostic scan tool, carry out the LIN New Module Initialization procedure (Toolbox> BCM > LIN New Module Initialization).
   

1. NOTE: This step is only necessary when installing a new component.

   Carry out the BCM self-test. Clear the Diagnostic Trouble Codes (DTCs) and then retrieve the Diagnostic Trouble Codes (DTCs) from the BCM to confirm all Diagnostic Trouble Codes (DTCs) have been cleared.