Ford Ecosport: Steering Wheel and Column Electrical Components / Removal and Installation - Ignition Switch
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the steering column shrouds.
Refer to: Steering Column Shrouds (501-05 Interior Trim and Ornamentation, Removal and Installation).
-
Disconnect the ignition switch electrical connector.
-
-
Release the ignition switch clips.
-
Remove the ignition switch.
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the steering column shrouds.
Refer to: Steering Column Shrouds (501-05 Interior Trim and Ornamentation, Removal and Installation)...
Special Tool(s) /
General Equipment
Pick Hook
Removal
NOTE:
Removal steps in this procedure may contain installation details...
Other information:
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
Remove the switch panel.
Disconnect the electrical connectors.
Use the General Equipment: Interior Trim Remover
Remove the screws...
Make sure the oil in the crankcase is of the correct
viscosity and at the correct level and that the battery is correctly
charged. Operate the vehicle until the engine is at normal operating
temperature. Turn the ignition switch to the OFF position...