Ford Ecosport: Engine Ignition - 2.0L Duratec-HE (129kW/175PS) / Removal and Installation - Ignition Coil-On-Plug
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
-
Remove the engine appearance cover.
-
Using compressed air, remove any foreign material from
the ignition coil-on-plugs and surrounding area. Remove the ignition
coil-on-plugs.
-
Slide the ignition coil-on-plug electrical connector
cover back to gain access to the locking tab, slide the locking tab back
away from the ignition coil-on-plug, depress the latch and then
disconnect the ignition coil-on-plug electrical connector. Remove the
ignition coil-on-plug bolts and then remove the ignition coil-on-plugs.
Torque:
89 lb.in (10 Nm)
-
Inspect the ignition coil-on-plug assembly for cracks,
rips or tears. Replace any damaged coil-on-plug assembly's.
Installation
-
To install, reverse the removal procedure.
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation)...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
WARNING:
Before beginning any service procedure in this
section, refer to Safety Warnings in section 100-00 General Information...
Other information:
System Operation
Heated Seats
The driver and passenger heated seat control buttons and indicators
are located on the HVAC
module. The heated seat system functions independently from the
climate control system. Each time the heated seat button is pressed, the
HVAC module decreases one setting (the sequence is high, medium, low,
off, high, etc...
Special Tool(s) /
General Equipment
206-D002
(D81L-1103-A)
Gauge, Brake Adjustment
Cable Ties
Adjustment
NOTE:
LHD shown, RHD similar.
Detach the parking brake control boot and position the boot upward on the handle...