Ford Ecosport: Front End Body Panels / Removal and Installation - Cowl Panel
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the cowl panel grille.
Refer to: Cowl Panel Grille (501-02 Front End Body Panels, Removal and Installation).
-
Detach the retainer and position the inlet manifold to brake booster vacuum pipe.
-
Remove the cowl panel mounting bolts.
-
Gently pull from the clips and remove the cowl panel.
-
NOTE:
This step is only necessary when installing a new component.
Remove the noise insulator from cowl panel.
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the active grill shutter.
Refer to: Active Grille Shutter - 2...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the windshield wiper pivot arm.
Refer to: Windshield Wiper Pivot Arm (501-16 Wipers and Washers, Removal and Installation)...
Other information:
B1142:62, B11D9:13, B13BF:14
Refer to Wiring Diagrams Cell 46 for schematic and connector information.
Normal Operation and Fault Conditions
The BECMB provides battery voltage to the RCM and OCSM . The BECMB
compares HS-CAN1 messages to ignition voltage inputs...
Special Tool(s) /
General Equipment
303-1249Valve Spring CompressorTKIT-2006UF-FLMTKIT-2006UF-ROW
303-1567Sizer, Teflon SealTKIT-2010C-FLM
303-300
(T87C-6565-A)
Set, Valve Spring CompressorTKIT-1988-FESTIVAT88C-1000-STTKIT-1988-TRACERTKIT-2009TC-F
303-350
(T89P-6565-A)
Compressor, Valve SpringTKIT-1990-LMHTKIT-1989-FTKIT-1989-FMTKIT-1989-FLM
..