Ford Ecosport: Exhaust System

Ford Ecosport 2014-2026 Service and Repair Manual / Exhaust System

Exhaust System - 2.0L Duratec-HE (129kW/175PS)

Installation - Transfer Case

Install the new input seal RH . Refer to: Transfer Case Input Shaft Seal RH (308-07B Transfer Case - 6-Speed Automatic Transmission – 6F35, Removal and Installation)...

Exhaust System - 2.0L Duratec-HE (129kW/175PS)

Other information:

Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - Transmission Support Insulator

Special Tool(s) / General Equipment 303-F072Support Bar, Engine Materials Name Specification Motorcraft® Threadlock and SealerTA-25-B - Motorcraft® Silicone Brake Caliper Grease and Dielectric CompoundXG-3-A ESA-M1C200-AESE-M1C171-A Removal With the vehicle in NEUTRAL, position it on a hoist. Refer ..

Ford Ecosport 2014-2026 Service and Repair Manual: General Procedures - Intake Manifold Vacuum Test

Bring the engine to normal operating temperature. Connect the Vacuum/Pressure Tester to the intake manifold. Run the engine at the specified idle speed. The vacuum gauge should read between 51-74 kPa (15-22 in-Hg) depending upon the engine condition and the altitude at which the test is conducted. Subtract 4.0193 kPa (1 in-Hg) from the specified reading for every..

Removal and Installation - Front Stabilizer Bar

Special Tool(s) / General Equipment

Tie Rod End Remover Transmission Jack

Removal

NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems. Failure of these fasteners may result in major service expense. Use the same or equivalent parts if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Tighten fasteners as specified.

NOTE: Removal steps in this procedure may contain installation details.

NOTICE: Disconnect the b