Ford Ecosport: Interior Lighting / Description and Operation - Interior Lighting - Overview
Overview
The interior lighting system consists of:
-
Courtesy lamps
-
Demand lamps
-
Ambient lighting
The courtesy lamps subsystem consists of:
-
Interior lamps
-
Door ajar switches (integrated into the door latches)
-
Courtesy lamp switch (integrated into the front interior lamp)
-
BCM
The
courtesy lamps provide illumination to the interior of the vehicle when
entering or exiting the vehicle or when requested using the courtesy
lamp switch located on the front interior lamp.
The demand lamps subsystem consists of:
-
Interior lamps (map lamps)
-
Vanity mirror lamps
-
Glove compartment lamp
-
BCM
The demand lamps are used to provide illumination to specific areas within the vehicle when needed.
The BCM energizes the demand lamp relay to supply voltage to the demand lamps when the battery saver feature is not active.
The ambient lighting subsystem consists of:
-
Ambient lighting light emitting diodes (LEDs)
-
BCM
The
ambient lighting provides illumination to the following locations for
illuminated entry or when the ignition is in RUN with the parking lamps
on:
-
Floor console cup holder
-
Front footwells
-
Front interior door release handles
-
Front door map pockets
System Operation
System Diagram - Interior Lighting
Item
Description
1
BCM
2
GWM
3
HS-CAN1
4
Door ajar switches
5
Front interior lamp
6
Rear interior lamp
7
Cargo lamp
8
Footwell lamps
9
Front door ambient lighting lamps
10
Cup holder ambient lighti..
Other information:
Initialization
NOTE:
Until the initialization procedure is complete, the one-touch open and one-touch close function is disabled.
NOTE:
An initialization procedure that was interrupted or not
completed can be started again after cycling the ignition from ON to OFF
and back to ON again.
An initialization procedure that was interrupted at the
hard stop can be starte..
Removal
Side obstacle detection control module
NOTE:
This step is only necessary if a SODL or SODR is being replaced.
NOTE:
If installing a new module, it is necessary to
upload the module configuration information to the scan tool prior to
removing the module. This information must be downloaded into the new
module after installation.
NOTE:
If a SODL or S..