Ford Ecosport: Evaporative Emissions - 2.0L Duratec-HE (129kW/175PS) / Description and Operation - Evaporative Emissions - Overview

Ford Ecosport 2014-2026 Service and Repair Manual / Engine / Evaporative Emissions - 2.0L Duratec-HE (129kW/175PS) / Description and Operation - Evaporative Emissions - Overview

Overview

The EVAP system prevents hydrocarbon emissions from entering the atmosphere by storing fuel vapors and routing the vapors to the engine to be consumed during normal engine operation.

The EVAP system consists of:

EVAP canister
EVAP canister purge valve
EVAP canister vent solenoid
EVAP blocking valve
Fuel Tank Pressure (FTP) sensor and tube
Easy Fuel (capless) fuel tank filler pipe

Evaporative Emissions - 2.0L Duratec-HE (129kW/175PS)

Description and Operation - Evaporative Emissions - System Operation and Component Description

System Operation System Diagram Item Description 1 Valve cover 2 Air Cleaner (ACL) outlet pipe 3 Vapor ejector 4 EVAP (Evaporative Emission) canister purge valve 5 Intake manifold 6 PCV (Positive Crankcase Ventilation) valve 7 EVAP canister 8 Fuel vapor v..

Other information:

Ford Ecosport 2014-2026 Service and Repair Manual: General Procedures - Active On-Demand Coupling Configuration

Configuration Using the diagnostic scan tool, under the toolbox icon select powertrain then select active on demand coupling barcode Entry. Follow the instructions displayed on the diagnostic scan tool. NOTICE: If the active active on demand coupling bar code information is not correct, rear drive unit (RDU) damage or driveability concerns can occur...

Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - Front Floor Panel Upper Rear Crossmember

Special Tool(s) / General Equipment 8 mm Drill Bit MIG/MAG Welding Equipment Spot Weld Drill Bit Locking Pliers Materials Name Specification Seam SealerTA-2-B, 3M™ 08308, LORD Fusor® 803DTM - Removal NOTE: Left hand (LH) side shown, right hand (RH) side similar. NOTE: Roof and body side removed for clarity..

Removal and Installation - Variable Camshaft Timing (VCT) Unit

Removal

NOTICE: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces, that enters the oil passages, coolant passages or the oil pan can cause engine failure.

Remove the timing chain.
Refer to: Timing Chain (303-01C Engine - 2.0L Duratec-HE (129kW/175PS), Removal and Installation).
Remove the bolts and VCT units.
Discard the bolts.