Ford Ecosport Owners and Service Manuals

Ford Ecosport: Side and Rear Vision / Description and Operation - Blind Spot Information System - Overview

Ford Ecosport 2014-2025 Service and Repair Manual / Electronic Feature Group / Side and Rear Vision / Description and Operation - Blind Spot Information System - Overview

Overview

BLIS ®

The BLIS ® aids the driver in assessing whether another vehicle is present within a specific area (blind spot) to either side of the vehicle, extending rearward approximately 4 m (13 ft) beyond the rear bumper while driving on roads and highways. The system is not designed to prevent contact with other vehicles or objects. The BLIS ® uses the exterior mirror BLIS ®/ CTA Light Emitting Diodes (LEDs) to alert the driver that a vehicle has been detected. The BLIS ® provides alerts to the driver when the vehicle is in a forward gear and the vehicle speed is greater than 8 km/h (5 mph).

CTA

When the vehicle is in REVERSE (R), the CTA system alerts the driver of vehicles that are approaching from the side when backing out of a front-in parking space or backing towards the road. The system can detect a vehicle approaching at a speed between 8 km/h and 60 km/h (5 mph and 37 mph) and time to impact is between 1 and 2.5 seconds. The CTA system uses the exterior mirror BLIS ®/ CTA Light Emitting Diodes (LEDs), a warning chime from the audio speakers and a message in the IPC message center to notify the driver of approaching vehicles.

NOTE: If a MyKey® restricted key is in use, the BLIS ® and CTA system cannot be turned off through the IPC .

    Description and Operation - Blind Spot Information System - Component Location

    C..

    Description and Operation - Blind Spot Information System - System Operation and Component Description

    System Operation BLIS ® and CTA System Diagram Item Description 1 SODL 2 GWM 3 PCM 4 BCM 5 ACM 6 DSP Module 7 LH exterior mirror 8 RH exterior mirror 9 LH BLIS ®/ CTA LED 10 with touchscreen..

    Other information:

    Ford Ecosport 2014-2025 Service and Repair Manual: Removal and Installation - Catalytic Converter


    Special Tool(s) / General Equipment Cable Ties Removal NOTE: If the catalytic converter is not being replaced, the HO2S and the catalyst monitor sensor do not need to be removed from the catalytic converter. Disconnecting the electrical connectors is still necessary. Refer to: Health and Safety Precautions (100-00 General Information - 2.0L Du..

    Ford Ecosport 2014-2025 Service and Repair Manual: Description and Operation - Acceleration Control - System Operation and Component Description


    System Operation Brake Over Accelerator The brake over accelerator feature may not be active during low speed operating conditions. This enables unique drive maneuvers, such as trailer tow, boat launch and retrieval, or operation in hilly environments, where the operator may require the application of both the accelerator pedal and the brake pedal during low speed maneuvering. Th..

    Categories

    Removal and Installation - Brake Disc Shield

    Removal

    NOTE: Removal steps in this procedure may contain installation details.

    Remove the brake disc.
    Refer to: Brake Disc (206-03 Front Disc Brake, Removal and Installation).
    Remove the bolts and brake disc.
    Torque: 80 lb.in (9 Nm)

    read more

    Copyright © 2025 www.foecosport2.com