Ford Ecosport: Driveshaft / Specifications
General Specifications
Item
|
Specification
|
Driveshaft runout
|
0.6 mm (0.024 in)
|
Driveshaft to PTU joint angle @ curb ride height
|
4.900º
|
Driveshaft center bearing joint angle @ curb ride height (Center bearing closest to the PTU)
|
0.954º
|
Driveshaft to RDU joint angle @ curb ride height
|
1.313º
|
Symptom Chart(s)
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation)...
Other information:
B0072:11, B0072:12, B0072:13, B0072:1A
Refer to Wiring Diagrams Cell 46 for schematic and connector information.
Normal Operation and Fault Conditions
The RCM continuously monitors the passenger seatbelt anchor pretensioner circuits for the following faults:
Resistance out of range
Unexpected voltage
Short to ground
Faulted passenger seatbelt anch..
System Operation
Cold Start Emission Reduction Monitor
The
cold start emission reduction monitor is an on board strategy designed
for vehicles that meet the low emissions vehicle-II (LEV-II) emissions
standards. The monitor works by detecting the lack of catalyst warm up
resulting from a failure to apply sufficient cold start emission
reduction during a cold start. There are 2 ty..