Ford Ecosport: Battery, Mounting and Cables / Specifications

Ford Ecosport 2014-2026 Service and Repair Manual / Battery and Charging System / Battery, Mounting and Cables / Specifications

Battery Specifications

Vehicles with AUTO-START-STOP
Item	Specification
Voltage	12 Volts
Cold Cranking Amps (CCA) measured at -18 C (-0.4 F)	760 Cold Cranking Amps (CCA)
Battery amps rating	70 Ah
Battery size	H6
Battery type	Absorbed Glass Mat (AGM)

Vehicles without AUTO-START-STOP
Item	Specification
Voltage	12 Volts
Cold Cranking Amps (CCA) measured at -18 C (-0.4 F)	500 Cold Cranking Amps (CCA)
Battery amps rating	52 Ah
Battery size	H5
Battery type	Starting, Lighting and Ignition (SLI)

Battery, Mounting and Cables

Description and Operation - Battery and Cables - Overview

Overview The battery and cable system consists of the following components: Battery Battery monitoring sensor Battery tray High current BJB Negative battery cable Positive battery cable ..

Other information:

Ford Ecosport 2014-2026 Service and Repair Manual: General Procedures - Transmission Fluid Drain and Refill

Materials Name Specification Motorcraft® MERCON® LV Automatic Transmission FluidXT-10-QLVC WSS-M2C938-AMERCON® LV, Draining With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation). If equipped, remove the bolts and the u..

Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - Active Torque Coupling Clutch

Special Tool(s) / General Equipment 205-126 (T78P-4851-A) Holding Fixture, Drive Pinion Flange Tire Lever Materials Name Specification Motorcraft® Silicone Gasket and SealantTA-30 WSE-M4G323-A4 Removal NOTICE: When replacing the RDU clutch, the ATC coil and yoke are a matched set and must be replaced also. NOTICE: ..

Removal and Installation - Front Stabilizer Bar

Special Tool(s) / General Equipment

Tie Rod End Remover Transmission Jack

Removal

NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems. Failure of these fasteners may result in major service expense. Use the same or equivalent parts if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Tighten fasteners as specified.

NOTE: Removal steps in this procedure may contain installation details.

NOTICE: Disconnect the b