Ford Ecosport: Automatic Transmission External Controls / Removal and Installation - Upshift Paddle Switch

Ford Ecosport 2014-2026 Service and Repair Manual / Automatic Transmission / Automatic Transmission External Controls / Removal and Installation - Upshift Paddle Switch

Removal

NOTE: Removal steps in this procedure may contain installation details.

Remove the RH steering wheel multifunction switch.
Refer to: Steering Wheel Multifunction Switch (211-05 Steering Wheel and Column Electrical Components, Removal and Installation).

Disconnect the upshift paddle switch electrical connector.

Remove the bolt and the upshift paddle switch.

Installation

To install, reverse the removal procedure.

Removal and Installation - Selector Lever Cable - 6-Speed Automatic Transmission – 6F35

Removal With the vehicle in N , position it on a hoist. Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation)...

Manual Transmission, Clutch, Transfer Case and Power Transfer Unit

Other information:

Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - B-Pillar Outer Panel

Special Tool(s) / General Equipment Resistance Spotwelding Equipment Hot Air Gun Air Body Saw MIG/MAG Welding Equipment Spot Weld Drill Bit Locking Pliers Materials Name Specification Metal Bonding AdhesiveTA-1, TA-1-B, 3M™ 08115, LORD Fusor® 108B, Henkel Teroson EP 5055 - Removal Depower ..

Ford Ecosport 2014-2026 Service and Repair Manual: Diagnosis and Testing - Pinpoint Test - DTC: AF, Vehicles With: Rear Seat Side Airbag

BXXXX:4A (any BXXXX DTC with a 4A failure type) Incorrect Component Installed Normal Operation and Fault Conditions The RCM monitors all SRS device connections. If the RCM detects a device connected but is not configured for that component, the RCM sets a DTC and sends a message to the IPC to illuminate airbag warning indicator. DTC Fault Trigger Conditions ..

Removal and Installation - Wheel Knuckle Bushing

Special Tool(s) / General Equipment

Hydraulic Press

Removal

NOTE: Removal steps in this procedure may contain installation details.

Remove the wheel knuckle.
Refer to: Wheel Knuckle - Vehicles With: Rear Drum Brakes (204-02B Rear Suspension - AWD, Removal and Installation).
Remove the rear toe adjustment retainers and remove the wheel knuckle mounting bracket.
Torque:
Stage 1: 177 lb.in (20 Nm)
Stage 2: 76 lb.ft (103 Nm)