Ford Ecosport: Rear Suspension - AWD / Removal and Installation - Spring
Special Tool(s) / General Equipment
| Spring Compressor | |
| Vise |
Removal
NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems. Failure of these fasteners may result in major service expense. Use the same or equivalent parts if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Tighten fasteners as specified.
NOTE: LH side shown, RH side similar.
NOTE: Removal steps in this procedure may contain installation details.
-
With the vehicle in NEUTRAL, position it on a hoist.
Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
-
WARNING:
Take extra care when handling the compressed spring.
NOTICE: When installing a suitable spring compressor, use care not to damage the spring coating.
Compress the coil spring enough to relieve the tension and remove the spring.
Use the General Equipment: Spring Compressor
Use the General Equipment: Vise
 |
Installation
NOTE: Make sure that the spring is correctly located in the upper and lower spring seat.
-
To install, reverse the removal procedure.
Removal and Installation - Wheel Knuckle - Vehicles With: Rear Drum Brakes
Special Tool(s) /
General Equipment
Flat-Bladed Screwdriver
Removal
NOTICE:
Suspension fasteners are critical parts that affect the
performance of vital components and systems...
Removal and Installation - Rear Shock Absorber
Special Tool(s) /
General Equipment
Transmission Jack
Removal
NOTICE:
Suspension fasteners are critical parts that affect the
performance of vital components and systems...
Other information:
Ford Ecosport 2014-2026 Service and Repair Manual: Diagnosis and Testing - Pinpoint Test - DTC: M, Vehicles With: Rear Seat Side Airbag
B0082:11, B0082:12, B0082:13, B0082:1A Refer to Wiring Diagrams Cell 46 for schematic and connector information. Normal Operation and Fault Conditions The RCM continuously monitors the passenger seatbelt load limiter circuits for the following faults: Resistance out of range Unexpected voltage Short to ground Faulted passenger seatbelt load limite..
Ford Ecosport 2014-2026 Service and Repair Manual: General Procedures - Fixed Glass
Special Tool(s) / General Equipment Glass Cut-Out Wire Power Caulk Gun Power Fixed Glass Removal Tool Cold Knife Knife Vacuum Cleaner Materials Name Specification Sika® SikaTack® MACH 60 / Sika® SikaTack® MACH 30 / Dow® BETASEAL™ Express - Sika Tack ASAP Urethane Adhesive - Motorcra..
Categories
- Manuals Home
- 2nd Gen Ford Ecosport Service Manual (2014 - 2026)
- General Procedures - Transmission Fluid Drain and Refill
- Specifications
- Removal and Installation - Starter Motor
- Removal and Installation - Fuel Pump and Sender Unit
- Diagnosis and Testing - Evaporative Emissions
Removal and Installation - Wheel Knuckle Bushing
Special Tool(s) / General Equipment
Hydraulic PressRemoval
NOTE: Removal steps in this procedure may contain installation details.
Remove the wheel knuckle.Refer to: Wheel Knuckle - Vehicles With: Rear Drum Brakes (204-02B Rear Suspension - AWD, Removal and Installation).
Remove the rear toe adjustment retainers and remove the wheel knuckle mounting bracket.
Torque:
Stage 1: 177 lb.in (20 Nm)
Stage 2: 76 lb.ft (103 Nm)
