Ford Ecosport: Exterior Trim and Ornamentation / Removal and Installation - Rear Fender Splash Shield
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH side similar.
-
Disengage the pushpin and the clips, position aside the rocker panel moulding.
-
Remove the pushpin and the retainers. Remove the rear bumper end cap.
Torque:
10 lb.in (1.1 Nm)
-
Remove the LH side rear wheel.
Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation).
-
Remove the pin-type retainers.
-
Remove the pushpins and the pin-type retainers. Remove the rear fender splash shield.
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH side similar.
Lower the door window glass...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH side similar.
Remove the front fender moulding...
Other information:
Check
WARNING:
Invisible ultraviolet and infrared rays emitted in welding
can injure unprotected eyes and skin. Always use protection such as a
welder's helmet with dark-colored filter lenses of the correct density.
Electric welding will produce intense radiation, therefore, filter plate
lenses of the deepest shade providing adequate visibility are
recommended...
Removal
WARNING:
The following procedure prescribes critical repair steps
required for correct restraint system operation during a crash. Follow
all notes and steps carefully. Failure to follow step instructions may
result in incorrect operation of the restraint system and increases the
risk of serious personal injury or death in a crash...