Ford Ecosport: Horn / Removal and Installation - Horn
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH horn shown, RH horn similar.
-
Remove the headlamp assembly.
-
Disconnect the electrical connector and detach the wiring retainer.
-
Remove the nut and the horn.
Torque:
18 lb.ft (24 Nm)
Installation
-
To install, reverse the removal procedure.
DTC Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation)...
Other information:
B11CF:11, B11CF:12, B11CF:13, B11CF:1A
Refer to Wiring Diagrams Cell 46 for schematic and connector information.
Normal Operation and Fault Conditions
The RCM continuously monitors the passenger airbag adaptive canister vent circuits for the following faults:
Resistance out of range
Unexpected voltage
Short to ground
Faulted passenger airbag adapt..
B00B5:11, B00B5:12, B00B5:13, B00B5:1D
Refer to Wiring Diagrams Cell 46 for schematic and connector information.
Normal Operation and Fault Conditions
The RCM continuously monitors the driver seat position sensor circuits for the following faults:
Open circuit
Short to voltage
Short to ground
Current out of range
Faulted driver seat po..