Ford Ecosport: Front End Body Panels / Removal and Installation - Fender Splash Shield

Ford Ecosport 2014-2026 Service and Repair Manual / Body and Paint / Front End Body Panels / Removal and Installation - Fender Splash Shield

Removal

NOTE: LH shown, RH similar.

NOTE: Removal steps in this procedure may contain installation details.

Remove the Wheels and Tires.
Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation).

Remove the Front Fender Moulding.
Refer to: Front Fender Moulding (501-08 Exterior Trim and Ornamentation, Removal and Installation).

- Remove the screws and washers.
- Remove the clips.
- Remove the rivet push pins.
- Remove the screws and washers.

Installation

To install, reverse the removal procedure.

Removal and Installation - Cowl Panel Grille

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the windshield wiper pivot arm. Refer to: Windshield Wiper Pivot Arm (501-16 Wipers and Washers, Removal and Installation)...

Removal and Installation - Engine Undershield

If equipped, remove the retainers and the under body shield. Torque: Stage 1: 13 lb.in (1.5 Nm) Stage 2: 22 lb...

Other information:

Ford Ecosport 2014-2026 Service and Repair Manual: General Procedures - Transmission Fluid Level Check

Materials Name Specification Motorcraft® MERCON® LV Automatic Transmission FluidXT-10-QLVC WSS-M2C938-AMERCON® LV, Check Connect the diagnostic scan tool to the vehicle. Monitor the TFT PID . With the engine running in PARK on a level surface make sure the transmission is at normal operating temperature 85-93° C (185-2..

Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - Reversing Lamp

Removal NOTE: RH side reversing lamp assembly shown, LH side similar. Remove the rear bumper cover. Refer to: Rear Bumper Cover (501-19 Bumpers, Removal and Installation). Disconnect the electrical connector. Release the tabs and remove the reversing lamp assembly. Installation ..

Removal and Installation - Variable Camshaft Timing (VCT) Unit

Removal

NOTICE: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces, that enters the oil passages, coolant passages or the oil pan can cause engine failure.

Remove the timing chain.
Refer to: Timing Chain (303-01C Engine - 2.0L Duratec-HE (129kW/175PS), Removal and Installation).
Remove the bolts and VCT units.
Discard the bolts.