Ford Ecosport Owners and Service Manuals

Ford Ecosport: Service Information / Identification Codes

General Procedures - Wire Terminal Inspection and Removal

Disconnect   WARNING: Before beginning any service procedure in this section, refer to Health and Safety Precautions in section 100-00 General Information...

Description and Operation - Identification Codes

Vehicle Identification Number (VIN) VIN Locator The VIN is a 17-digit combination of letters and numbers. The VIN is printed on a metal tab attached to vehicle and visible through the windshield lower left corner...

Other information:

Ford Ecosport 2014-2025 Service and Repair Manual: Description and Operation - Engine Ignition - System Operation and Component Description


System Operation Cold Start Emission Reduction Monitor The cold start emission reduction monitor is an on board strategy designed for vehicles that meet the low emissions vehicle-II (LEV-II) emissions standards. The monitor works by detecting the lack of catalyst warm up resulting from a failure to apply sufficient cold start emission reduction during a cold start...

Ford Ecosport 2014-2025 Service and Repair Manual: General Procedures - Bearing Inspection


Inspection Cratering - fatigue failure Spot glazing - incorrect seating Scratching - dirty engine oil Base exposed - poor lubrication Both edges worn - journal damaged One edge worn - journal tapered or bearing not seated ..

Categories

Removal and Installation - Wheel Knuckle Bushing

Special Tool(s) / General Equipment

Hydraulic Press

Removal

NOTE: Removal steps in this procedure may contain installation details.

Remove the wheel knuckle.
Refer to: Wheel Knuckle - Vehicles With: Rear Drum Brakes (204-02B Rear Suspension - AWD, Removal and Installation).
Remove the rear toe adjustment retainers and remove the wheel knuckle mounting bracket.
Torque:
  Stage 1:  177 lb.in (20 Nm)
  Stage 2:  76 lb.ft (103 Nm)

read more

Copyright © 2025 www.foecosport2.com