Ford Ecosport: Roof Opening Panel / General Procedures - Roof Opening Panel Manual Closing
Adjustment
-
Remove the overhead console.
Refer to: Overhead Console (501-12 Instrument Panel and Console, Removal and Installation).
-
Rotate the retainer clockwise to close the roof opening panel manually.
Initialization
NOTE:
Until the initialization procedure is complete, the one-touch open and one-touch close function is disabled.
NOTE:
An initialization procedure that was interrupted or not
completed can be started again after cycling the ignition from ON to OFF
and back to ON again...
Adjustment
Remove the overhead console.
Refer to: Overhead Console (501-12 Instrument Panel and Console, Removal and Installation).
Rotate the retainer counterclockwise to open the roof opening panel manually...
Other information:
BXXXX:2B, BXXXX:81 (any BXXXX DTC with a 2B failure type, or any impact sensor with an 81 failure type) Signal Cross Coupled
Refer to Wiring Diagrams Cell 46 for schematic and connector information.
Normal Operation and Fault Conditions
The RCM
monitors all deployable device and sensor circuits for a signal cross
coupled (short) between components...
Special Tool(s) /
General Equipment
Tie Rod End Remover
Transmission Jack
Removal
NOTICE:
Suspension fasteners are critical parts that affect the
performance of vital components and systems. Failure of these fasteners
may result in major service expense...