Ford Ecosport: General Information / Description and Operation - Diesel Fuel System Health and Safety Precautions
Ford Ecosport 2014-2026 Service and Repair Manual / Service Information / General Information / Description and Operation - Diesel Fuel System Health and Safety Precautions
WARNING:
Do not work on the fuel system until the pressure has been
released and the engine has cooled. Fuel in the high-pressure fuel
system is hot and under very high pressure. High-pressure fuel may cause
cuts and contact with hot fuel may cause burns. Failure to follow these
instructions may result in serious personal injury.
Description and Operation - Gasoline and Gasoline-Ethanol Fuel Systems Health and Safety Precautions
WARNING:
Before working on or disconnecting any of the fuel tubes or fuel
system components, relieve the fuel system pressure to prevent
accidental spraying of fuel...
Description and Operation - Pyrotechnic Device Health and Safety Precautions
WARNING:
Service and handling of Pyrotechnic Components is restricted to
qualified personnel. The required qualifications vary by region...
Other information:
Ford Ecosport 2014-2026 Service and Repair Manual: General Procedures - Transport Mode Deactivation
Deactivation NOTE: After vehicle build, some vehicle modules are set in Transport mode including the IPC and the BCM . Transport mode reduces battery drain during longer periods where the vehicle is not used. While in transport mode, the IPC displays TRANSPORT MODE CONTACT DEALER in the message center...
Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - Block Heater
Removal NOTE: Removal steps in this procedure may contain installation details. WARNING: Before beginning any service procedure in this section, refer to Safety Warnings in section 100-00 General Information. Failure to follow this instruction may result in serious personal injury...
Categories
- Manuals Home
- 2nd Gen Ford Ecosport Service Manual (2014 - 2026)
- Removal and Installation - Body Control Module (BCM)
- Engine
- Specifications
- Description and Operation - Evaporative Emissions - System Operation and Component Description
- General Procedures - Transmission Fluid Level Check
Removal and Installation - Variable Camshaft Timing (VCT) Unit
Removal
NOTICE: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces, that enters the oil passages, coolant passages or the oil pan can cause engine failure.
Remove the timing chain.Refer to: Timing Chain (303-01C Engine - 2.0L Duratec-HE (129kW/175PS), Removal and Installation).
Remove the bolts and VCT units.
Discard the bolts.
Copyright © 2026 www.foecosport2.com