Ford Ecosport: Transfer Case - 6-Speed Automatic Transmission – 6F35 / Specifications

Ford Ecosport 2014-2026 Service and Repair Manual / Manual Transmission, Clutch, Transfer Case and Power Transfer Unit / Transfer Case - 6-Speed Automatic Transmission – 6F35 / Specifications

Capacities

Item	Specification	Fill Capacity
Motorcraft® SAE 75W-85 Premium Synthetic Hypoid Gear Lubricant XY-75W85-QL	WSS-M2C942-A	9.30 ± 0.85 fl oz ( 275 ± 25 ml)

Transfer Case - 6-Speed Automatic Transmission – 6F35

Description and Operation - Transfer Case - Overview

Overview NOTE: Serviceability of the transfer case is limited to seals and the output flange. If any of the geared components, bearings, cases, covers or internal shafts fail, a new transfer case must be installed...

Other information:

Ford Ecosport 2014-2026 Service and Repair Manual: Diagnosis and Testing - Air/Fuel Ratio

Diagnostic Trouble Code (DTC) Chart Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation). Module DTC Description Action PCM P0030:00 HO2S Heater Control Circuit (Bank 1, Sensor 1): No Sub Type Information GO to Pinpoint Test D..

Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - Front Bumper

Special Tool(s) / General Equipment Knife Removal NOTE: Removal steps in this procedure may contain installation details. Remove the front bumper cover. Refer to: Front Bumper Cover (501-19 Bumpers, Removal and Installation). NOTE: LH side only. Detach the retainer and position the wiring harness aside. ..

Removal and Installation - Front Stabilizer Bar

Special Tool(s) / General Equipment

Tie Rod End Remover Transmission Jack

Removal

NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems. Failure of these fasteners may result in major service expense. Use the same or equivalent parts if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Tighten fasteners as specified.

NOTE: Removal steps in this procedure may contain installation details.

NOTICE: Disconnect the b