Ford Ecosport: Handles, Locks, Latches and Entry Systems / Removal and Installation - Keyless Entry Rear Antenna
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the luggage compartment floor cover.
-
Position the liftgate weatherstrip aside.
-
Remove the load compartment scuff plate trim panel.
-
Remove the pin-type retainers.
-
Release the clips and the locator pins.
-
Disconnect the keyless entry rear antenna electrical connector.
-
NOTE:
This step is only necessary when installing a new component.
Remove the keyless entry rear antenna
-
Remove the screws.
-
Remove the keyless entry rear antenna and bracket assembly.
-
Remove the keyless entry rear antenna from the bracket assembly.
Installation
-
To install, reverse the removal procedure.
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
LH side shown, RH side similar.
Remove the rear door trim panel...
Removal
NOTE:
LH side shown, RH side similar.
NOTE:
Removal steps in this procedure may contain installation details.
Refer to: Rear Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation)...
Other information:
Overview
The BCM
monitors the tire pressure in the 4 road tires with tire pressure
sensors that communicate the tire pressure via radio signals to the BCM .
The tire pressure sensors are battery operated and mounted to the valve
stems. All of the controlling software for the TPMS is contained in the
BCM ...
Overview
Driver Power Seat
The 6-way driver power seat is equipped with the following motors:
Rear height motor (serviced with seat track assembly)
Horizontal motor (the only seat track motor which can be serviced separately from the seat track assembly)
Recliner motor (serviced with seat backrest assembly)
Heated Seats
This
system allows on-demand,..